Blocking specific airports while overflying them - MSFS

[G-YMML1 582]

Hello,

 

Is it possible to block specific airports from generating ground traffic. Was flying today KIAD-KBOS and a mix of KLGA/KEWR/KJFK put a lot of pressure on my system. Limiting range down to 5 miles does not really help.


Thanks in advance

[kiek 1,215]

On 1/11/2023 at 3:12 AM, G-YMML1 said:

Is it possible to block specific airports from generating ground traffic. 

That should have been the case... You should only see ground traffic at your origin or destination airport, nowhere else. Unfortunately a bug slipped in a few monts ago I think.

But I have fixed it, try 33.4.1 or later.

[G-YMML1 582]

3 hours ago, kiek said:

That should have been the case... You should only see ground traffic at your origin or destination airport, nowhere else. Unfortunately a bug slipped in a few monts ago I think.

But I have fixed it, try 33.4.1 or later.

But how will PSXT know my origin and destination? I use "Learn Destination" at that's all. PMDG and Fenix only, no default flightplants.

[kiek 1,215]

28 minutes ago, G-YMML1 said:

But how will PSXT know my origin and destination? I use "Learn Destination" at that's all. PMDG and Fenix only, no default flightplants.

Your origin is where you are at the ground at an airport that goes automatically,  and your destination you should either fill in in the GUI (don't forget to press enter after you have typed the ICAO code ) or PSXT will take it from your flight plan automatically (if in use), se ethe Manual about that..

Learn Destination is something differnt, but for that you also have to fill in the destination in the GUI.

Edited January 12, 2023 by kiek