Full Reverse Thrust?

[G7USL 117]

Does anyone know how to assign the 'Saitek Pro Flight Yoke System' to give FULL reverse thrust?I have the throttle (red section) already assigned for 'F2' but that only gives 'Idle reverse' and cannot obtain 'full' reverse using my hardware.The only alternative is to hold down the F2 key.Any constructive advise please?

[glacier 0]

I have the Saitek X52 Pro and the only way for me to get reverse on my throttle is via FSUIPC. My throttle has a detent so I assinged reverse below the detent in the FSUIPC throttle axis. I'm not familiar with your Saitek yoke, but in your case you could assign a button to the F2 key and hold the button whenever reverse is required.

[Glynn 405]

helloI also use FSUIPC with the reverser button at the end of the throttle throw set as throttle_n dec with repeat checked and also "on release" set to throttle_n cut.you may be able to do it in FSX's assignments by setting the F2 repeat rate full right.http://www.freewebs.com/reading1871/30.jpg

[irocx 292]

Hi Dave, When you assign the F2 button within the FSX control options, drag the "repeat" slider all the way to the right and that should give you full reverse thrust when you hold down the controller button. This works on my CH yoke and the Lear45. Regards, Kendall#1: E8500 @ 3.95 - HyperTX2 Gigabyte P35-DS3L 4GB Ballistix Tracers PC6400 EVGA 8800GT - XG's 174.74 Seagate 250GB 7200.11 CH Yoke/Pedals/Saitek Throttle Dual Monitor: Dell 2405/1905 #2: Dell 8400 3.2 H.T. 3GB PC4200 - X800XT Diamond Xtreme/Logitech X-530's

[G7USL 117]

Thanks Kendall, it works now. ;)