Yesterday at 05:54 PM1 day Does anyone know if it offer ATC chatter enroute or how can it be increased? It's too quiet for me. 😁 MSFS
Yesterday at 06:45 PM1 day 47 minutes ago, CFIJose said:Does anyone know if it offer ATC chatter enroute or how can it be increased?It's too quiet for me. 😁If you go into the pilot portal of SI and then to settings/ traffic injection settings, further down the page are sliders to add chatter. The planes don't actually exist but you have more chatter to listen to. I agree that they need to increase enroute traffic injection.
Yesterday at 06:50 PM1 day Author This always happens. I asked a question and a few minutes later I discovered that there are settings in the portal that need to be enabled. MSFS
Yesterday at 06:52 PM1 day Author I must say that my 1st flight was very good experience. Let's see if the next flight is just as much fun! MSFS
20 hours ago20 hr Over the past week or so, they’ve made some major improvements. Still needs work though, but overall it’s very good. I’d highly recommend trying out the IRIS voice engine. Response times are very very good, lots of chatter (mostly planes checking in, getting climb and descent clearances). Compared to where it was just a week ago, it feels like a new product. I’d say they are about 60% there, still needs some more nuanced attention to make it the full way. But IMO it just inched past BATC as far as the ATC side of the program goes. BATC has vastly better traffic control and fluidity, but the ATC to user interactions feel much better in SI. AMD 9950X3D | 64 GB RAM | RTX 5090 FMR: 747 FO, 757/767 CAPT, 737 Check Airman Current 777 CAPT
19 hours ago19 hr V1ROTATE, I'm guessing United Airlines. i7-6700k • Gigabyte GA-Z170X-UD5 • 32GB DDR4 2666 • EVGA FTW ULTRA RTX3080 12GB
11 hours ago11 hr Author 9 hours ago, V1ROTA7E said:Over the past week or so, they’ve made some major improvements. Still needs work though, but overall it’s very good. I’d highly recommend trying out the IRIS voice engine. Response times are very very good, lots of chatter (mostly planes checking in, getting climb and descent clearances). Compared to where it was just a week ago, it feels like a new product. I’d say they are about 60% there, still needs some more nuanced attention to make it the full way. But IMO it just inched past BATC as far as the ATC side of the program goes. BATC has vastly better traffic control and fluidity, but the ATC to user interactions feel much better in SI.The ATC chatter is a mess. I see why it's disabled on initial install.I was able to do a couple of IFR flights. I have not tried the VFR portion.24 hours is not enough time to fully test this complex add-on. Maybe, I'll try it again in 6 months. Maybe by then BATC will finally get fixed. For me, the last update, was a step in the wrong direction. MSFS
Create an account or sign in to comment