exbuilder problem

[Guest thrimur]

Hi all,I want to get rid of one taxiway sign, I tried using exbuilderV2 like I have done before but now I get error message saying that latitudemin must be smaller than latitudemax, here is the xml codewhat am I doing wrong? I have used exbuilder before, but that was before service pack2 and 9.1 patch do I have to install something again?<?xml version="1.0"?>thrimur

[wsieffert 0]

Start the flight simulator, slew to the sign, press the SpaceBar and the aircraft will face North. Slew the aircraft to the Northwest corner, press the Excludebuilder buttons for LAT/LON, slew to the Southeast corner, press the Excludebuilder buttons for LAT/LON. Enable the various options, save if you like, keep the XML if you like, then compile.Remember, you must face North to ensure you get the NW/SE corners.W. Sieffert

[Guest thrimur]

thanks for reply, I followed your instructions to the letter, pressed spacebar the aircraft faced 020

[rhumbaflappy 113]

Hi thrimur.65,6519224731214should be:65.6519224731214You may need to set your computer to use the USA decimal designation of a "." rather than the European ","Dick

[Guest thrimur]

Thanks Dick, that was the solution, it the same problem I had with the Gmax export module a while back.It works now, thanks for the helpthrimur