Jump to content

Sign in to follow this  
Forkboy2

AI aircraft hanging in midair...

Recommended Posts

Guest

Hi Folks,after designing and installing an addon scenery with an according afcad layout, I happen to have a strange phenomena.On FS startup, all traffic is properly placed at gates/parking etc. All behaves well (within fs and flightplan limits) until I do a trip myself. On arriving at this specific airport, the aircraft hang in midair, about 110 ft over their parking positions. Departing traffic "beams down" to the apron before taxiing out normally. Arriving traffic behaves normal, too.I had to use a flatten area to have the area useable for this (new, no MS-default) airport. May this affect the AI positions when the airport area is out of visual range?Any help is welcome...Thanks,Torsten

Share this post


Link to post
Share on other sites
Guest

Dear Matt,thanks for Your reply, I tried that already. Altitude in the airports.txt is the same as the scenery altitude defined in airport as is the flatten altitude...TM

Share this post


Link to post
Share on other sites

How about the reference point and also the tower locations in AFCAD. Those both have elevations also.Matt

Share this post


Link to post
Share on other sites
Guest

Dear Matt,a VERY BIG THANK YOU again... My AFCAD ref point was more than 100ft over the scenery and I guess that caused the unusual looks. I changed it to scenery alt, started a short flight and voil

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...