RC Sending Plane to N0.00 W0.00 - It's wet, dark and scary!

[flyingscampi 2]

The problem only occurs from airports located within the Portland scenery from http://www.flightscenery.com that I've just installed.I start RC and load the flight plan, start FS9 and setup the flight at a KPDX gate, switch out and start rc and when I return to FS9 the plane has moved to N0.00 W0.00.After a few seconds, FS9 reloads the scenery and puts the plane back where it started but RC has crashed.I've rebuilt the RC scenery database after installing Portland scenery.Any ideas?RC is a great product btw

[jd 57]

sounds awfully familiar to this posthttp://forums.avsim.net/dcboard.php?az=sho...id=23406&page=2are you using fsbuild?jd

[flyingscampi 2]

A-ha. That's the same problem because I AM using FSBuild! I'll see if I can find anything over at the FSBuild forums. Sorry I blamed RC...Thanks for your very quick response :)

[flyingscampi 2]

HiThe problem was caused by an incompatibility between RC and an AFCAD file that comes with the Portland scenery.I found the solution here (I swear I searched for Portland before posting!):http://forums.avsim.net/dcboard.php?az=sho...e=&topic_page=1

[John Burgess 0]

Hi there,Just to let you know that if you use the latest version of makerwys (v3.97 or later) there is no longer a problem with the Portland scenery. v3.97 is available as part of the RCv4.3 update.All the best,John

[jd 57]

http://forums.avsim.net/dcboard.php?az=sho..._id=23615&page=