Simghost

Hi All, I am new to Panel Builder and apologize if the answer to my question is obvious. I have looked through the documentation and forum and could not find the information I need. I am Running P3DV2.2 on the 1st computer utilizing 2 displays. The large display(39" 1080P television) is used for my view out the window(scenery), the second display is for my GPS. I also am running a second computer with 2 displays that I am going to use to run Panel Builder and a few other addons (ASNext, etc...). The problem I am having is on the second computer(Laptop), the second display is extended from the laptop display. When I run my panel it always defaults to the upper left of the laptop and not my extended display the 27" monitor. I would like to have the entire panel on the 27" monitor as I am going to use this in a home cockpit. The answer my be obvious, but not to this old guy. Thanks to anyone that can help me, Robert Davis Sorry everyone but I solved my problem minutes after this post. I wanted to leave it here in case it helped anyone else. I was missing the fact the I could change in my display setting which display would be the primary display. I swapped the two and now Panel Builder displays on the top left corner of the display I wanted it too. Problem solved.

my window does not look like that. I have a screenshot but don't know how to make it so you can see it. I do not have a selection box at the bottom of the window to select what ATC I am using. The only button there says "reset defaults". The bar at the top says "ATC Realism: Using FS Native ATC". My window does not match that in the pdf file for using PFE. Any other suggestions?

That sounds like it should have been a no brainer. I'll try that tonight. For some reason i thought it was going to sense PFE being loaded and switch automatically. I guess we want computers to do everything for us :blink:

Hi Everybody, I'm a new user of MCe but so far I am having a great time learning to use it. So far I have used it with FSX ATC and everything is working fine. Usually I use PFE for my ATC but it doesn't appear that MCE is recognizing that I have PFE running. On the ATC tab it still shows it is utilizing FSX ATC. I read the Help file for using PFE and made the selections outlined there for both MCE and how PFE is setup. But when everything is up and running it still doesnt know that I am using PFE. Does anyone use PFE and can tell me the steps I need to take to make it work. How does MCE know if PFE is being used to acknowledge it in the ATC tab? Thanks for any info. Robert