ssrin

Thanks a lot. Line selecting the next way point and inserting it as the next active waypoint solved my issue.

Hello, I was trying to setup a flight plan from KAUS to KSAT on my PMDG 737 NGX FMC. I chose runway 35L AUS3 SID. I chose STV (stonewall) for the transition option in AUS3 SID. For the arrival section in KSAT, I wanted ILS 12R, STV (STAR), REUBE (Transition). I wanted to use CWK. AMUSE. STV. STV1. REUBE. ALAMO . RUNWAY12R for my route. No matter what I tried , I would end up with an FMC RTE with an initial heading vector from KAUS followed by CWK.AMUSE.STV.STV1.REUBE and the rest of the route to 12R. I had both LNAV and RNAV armed and at 600ft enabled CMDA to turn on the autopilot. However the aircraft just keeps flying on the initial vector in my flight plan. it fails to turn in the direction of the route . Everything from CWK to runway 12R is in a magenta color and looks continuous with the runway vector line intercepting the magenta line. I'm kind of stumped on how to get the aircraft to transition from the runway heading vector onto the actual route. For some reason my route essentially turned into 2 segments with one being a vector and the other being a full route from CWK to my final destination but the 2 segments are disjoint during the flight. The FMC RTE/LEGS page doesn't show any route discontinuities. I am not sure how to proceed. Hoping to get some pointers. Thanks S.Srinivasa