Search the Community
Showing results for tags 'GNS430'.
Found 4 results
The reality XP GNS 430 appears to be responding incorrectly to XPlane zoom In/zoom Out commands: "sim/GPS/g430n1_zoom_in" and "sim/GPS/g430n2_zoom_out" Zoom In should reduce the range, Zoom out should increase the range. Easiest way to demonstrate is to put the Xplane and RealityXP 430s side by side. Then press the zoom in (down arrow) and zoom out (up arrow) buttons on the XPLANE 430. You will see that the up arrow zooms IN and the down arrow zooms OUT. Note: The Reality XP 430 responds correctly to presses of its own buttons, but incorrectly to the XPlane commands: Why it matters? Prevents proper integration with other X-plane developments (e.g. Air Manager)
RealityXP Carenado Baron B58 by Jul79_, auf Flickr Hello, As seen in the photo, there's a native RealityXP .ini in the Carenado Baron B58. I wasn't able to do it, but can anyone of you create one that also replaces the GNS430 at the bottom with a GTN650? Julius
Firstly Jean-Luc and the guys - great job !! Have been waiting for this since Christmas and it hasn't disappointed. I swung over to P3D some time back but have been frustrated with no realistic 430 to practice IFR. Don't expect to get the 10+ years of use I got out of version 1 but am looking forward to pushing it. Have come across an issue that I'm pretty sure is a bug. I first noticed it when I added an approach to a flight plan then couldn't get the Autopilot to pick up a change to selected way point. Am using the standard keying - FPL then curser to pick new target waypoint then -> to activate direct to or ->/-> to activate leg. All works fine in the GPS but autopilot, and plane stays on last leg selected. After this I have tried it when doing en-route way point changes with same result. Have tried doing a switch to HDG and back to NAV to reset but no joy. Have also tried various combinations of GPS to autopilot in the settings screen. Finally tried it in the base C172 to make sure it wasn't a problem with the CIrrus I was in but am getting same result. Hope we can fix. regards PatrickF https://www.dropbox.com/s/lnvuabnrffv4z6f/SR20_sequencing.jpg?dl=0 https://www.dropbox.com/s/og65pk9t4zundib/C172_sequencing1.jpg?dl=0 https://www.dropbox.com/s/c350lu7uvnnrgop/C172_sequencing2.jpg?dl=0
I'm considering buying the A2A 172 but only if I can integrate the RXP GNS430W into the 3D panel and use all modes. I've read some old posts in the A2A forums that said there was an issue using NAV AP mode and integrating with the CDI. I figured all this out for the Carenado Archer and assume I can do the same for the A2A 172. Is there any known issues I'm not going to be able to overcome? I'm also going to switch to P3D some day. Is the RXP GNS430/530 P3D coming soon? Thanks, Bruce