Search the Community
Showing results for tags 'Lever'.
Found 1 result
Good afternoon / evening folks, This morning I experienced something strange on my 747. First let me note that a few minutes prior to the incident I had run the Operations Center and updated the tool, and also the plane itself through said program. Both updates appeared as a prompt / alert on OC. Don't know if that could have caused an issue as I have never had this before. After updating, I was trying to run a very short flight (load the short stop panel state while parked at a gate, run a preflight, power the plane and perform a traffic pattern). However, after starting the engines as per checklists, they were completely unresponsive. I could see the white "dash" (?) (or I could call it the target thrust indicator?) on the EICAS engine N1 indicator move up and down and also the thrust levers did move physically, but thrust would remain at idle. Tried both with the hardware (Saitek Pro Flight Yoke + 1 Throttle Quadrant) and also with the keyboard (F2/F3) but no thrust change or spool up sound at all. Did I do something wrong or maybe did the update corrupt something? I have to admit though that I did not restart the simulator and try again because I was about to leave for work, will try once I get back home. I also tried searching on forums to avoid a double post but didn't find this same scenario, so even if it ends up being a silly mistake by myself or a possible bug, it could help anyone who might experience this in the future. Thanks in advance! Regards,