Search the Community
Showing results for tags 'PSXseecon'.
Found 2 results
-
Hi everyone I've recently started to use PSXseecon along with RealTraffic but I have a rather peculiar problem. The pair work great at most airports but at certain airports (EDDF for example) the PSXseecon injects all the parked aircraft, but no live traffic, and after a few seconds the PSXseecon client crashes with no warning or error and all the parked traffic disappear too. If I run the pair on a networked PC basically the same thing happens with the difference being PSXseecon client freezes and causes the entire client system to freeze too and I have to restart the client PC. Any help or assistance would be much appreciated. Thanks
-
Hello Nico, I hope you are doing well. I am (finally!) finishing my 747 cockpit and still using your fantastic software. I am facing some issues I would like to discuss with you : - My hardware yokes have built-in push-to-talk buttons which are interfaced with PSX using a Leo Bodnar card (USB device). These buttons are set in the PSX's USB Tab as "CPT" and "F/O" PTT. My problem is that there are also PTT buttons on my glareshield wings, and those are interfaced using PSXSeecon (variables 1082 and 1093). No problem when using the glare wings PTT, but when I push the PTT on my yokes, the virtual switch in PSX is immediately brought back to its release position, because I think PSXSeecon wants to remain its position synchronized with my glare wing buttons. Is it possible to update PSXSeecon (or add an option in the cfg file) to disable the position slaving between PSXSeecon and PSX for those 2 variables ? - I don't find any suitable dual concentric encoder for my RCPs. My actual encoders are 32 detents/revolution and 2 pulses/detend which makes SIOC behaving crazy and the frequency tuning impossible, even with "Aceleration" set to 0. The problem is that I don't find any suitable DUAL CONCENTRIC encoder having the characteristics required by the Opencockpit master cards, I only find single shaft with pushbutton. If by chance you knew where I could get them, please let me know. Meanwhile, I see two solutions : - Is there a way to change the encoder behaviour at the software side ? I tried some basic SIOC scripts without success. - A solution could be trying with a single shaft encoder equiped with a pushbutton. Every push will swap between frequency absolute and decimal setting. However, I don't see how to do because the variables defined in PSXSeecon (BigFreqKnobL , 3691 and SmallFreqKnobL , 3692 for example) are designed to be assigned with a single encoder in a single definition. I don't see how to tell PSXSeecon "Move the BigFreqKnobL first, then when I press the pushbutton, swap to the SmallFreqKnobL, and do this with the same encoder". I am requesting your help and advices. Thanks in advance. Kind regards, Jean-Philippe