Search the Community
Showing results for tags 'bleed'.
Found 2 results
-
As you can see in the pic (click link below), the FSX logo bleeds through the PMDG 747-8 EFB. I also have the bleed-through problem in the PMDG 777, but not in the NGX or any other aircraft. I uninstalled and reinstalled the 747-8 and it temporarily fixed the problem, but it returned. The EFB opened in a 2D window displays just fine.I've used Steve's DX10 Fixer to no avail. Interestingly this problem does not occur with DX9, but DX9 causes OOMs with this bird so I need to use DX10.Has anyone else had this problem? Does anyone have any ideas? CLICK HERE FOR PIC: https://www.dropbox.com/s/s5o5jqs1tj6rfzz/Picture1.png?dl=0 Gus WhiteUAL1063
-
With the 737 on the FSX I'm facing this odd problem the last time: I start the engines with the APU as normal, the starters cuts out and I can switch on the engine generators. But they won't produce any bleed air and they won't react on my throttle inputs, while the thrust levers are moving and the takeoff configuration warning horn sounds. Another odd fact: The are only at an idle n1 of about 20 %. If I save this panel state and reload it, I got an engine failure and they have miraculously stopped. PMDG Setup also says, there are no active failures. Even if I restart them they won't react, but sometimes, if I choose another livery or hitting <control>+<E> helps. (I'm aware of the isolation valve and packs should be off while starting etc.) Any suggestions?
- 11 replies
-
- fsx/fsx-se?
- 737
-
(and 7 more)
Tagged with: