Search the Community
Showing results for tags 'buttons'.
Found 4 results
LINDA Button limit - Leo Bodnar 64 Cards
Th3Scop3DJ posted a topic in LINDA SupportHi there, I know Windows ans FSUIPC are limited to recognise more than 32 buttons per device. How is it with LINDA? Are there any limitations? Could I use a Leo Bodnar BBI-64 Button Box Interface and would LINDA recognise all buttons? Thanks 🙂
I was so frustrated that I couldn't make individual custom axis profiles for each aircraft in MSFS, but I should have known that a smart developer would alleviate me of this frustration before too long. I just bought a program called Axis and Ohs by Lorbi (which is available to try for free), which makes setting custom controller axis and button profiles and templates a breeze. It's so easy to use! Has anyone tried this program yet? I'm surprised that I haven't heard a lot of excitement over this utility. It's genius and it works so well and solves a really big problem with MSFS (it also works with FSXSE and P3D!). You can change controller settings on the fly without having to go back to the main menu. I know that FSUIPC does the same thing in P3D, but Axis and Ohs (silly name!) works so much easier and cleaner than FSUIPC that I'm going to start using it for P3Dv5 also, instead of FSUIPC. This great utility is under $12 and it's free to try out. Please tell me if anyone else has tried this and is as excited about this utility as I am. I am amazed at how easy it is to use! Also Lorbi gives the best support.
can't specify BU0836A interface
Pawel S posted a topic in Pilot2ATC Bug Reporting Forumhello! My setup have two identical BU0836A cards to control yoke and rudder pedals. When I specify under set PTT particular one (when there is reaction to button pushed) and save. Wrong (first on the list) interface card is used and Pilot2ATC reads switch status from wrong device. When I open config again wrong BU0836A is set after window opens. This was confirmed by pluging off second (first on the list) one. And with just one it works perfectly. version: 18.104.22.168_r3 best regards! pawel
Bug with Chronometer countdown timer
Mustang-242 posted a topic in PMDG Turboprops (Legacy Versions)Hello, Whilst getting re-acquainted with the J41 I've been going through the cockpit along with the Introduction manual, learning a few little tricks and lesser-known or lesser-used features along the way. I must have read it all once before but I've slept a few times since then. Anyway, with the Davtron Chronometer (page 24 of the intro manual), I seem to have found a bug when setting the ET count-down timer. Steps to reproduce: Click SEL until in the ET count-up mode. Right-click the CTL button to switch to programming the count-down mode. Enter the desired time using the SEL button to step through the digits and CTL button to increment each digit. Finish setting the count-down time using SEL after the last digit. Observe how the digits are swapped for the selected number of seconds. As an example, if you set a countdown of 1 second (00:01) it will switch to 00:10 (10 seconds) after you finish the entry. If you set it to countdown from 12:34, it will swap to 12:43. Possibly an already-known bug, but I didn't find it with a search of this forum. Small one to fix for whenever the J41 gets some love for FSX:SE & P3D. That's not a hint! Or it might be :wink: (I'm still on FSX until I next reinstall Windows 10, so I'm OK for the time-being.) Many thanks, Martyn