Hi Guys,I have a couple questions. Has the panel light issue been solved where at times it will cause a few gauges not to appear until you switch the light off? I couldn't find a solid answer by searching.The second question:Yesterday I was going through my checklists, and by mistake clicked on the fire extiguisher switch for engine #1. I then set it back to normal position, and continued with the checklists.When I went to start engine #1, it wouldn't kick over. It just keep cycling over and over. I then realized what I had done, and couldn't find a way to reset it without re-loading the flight again.Is there a way to reset the fire system without having to reload the flight?Thanks in advance,John

bump...

>Hi Guys,>>I have a couple questions. Has the panel light issue been>solved where at times it will cause a few gauges not to appear>until you switch the light off? I couldn't find a solid>answer by searching.>>The second question:>>Yesterday I was going through my checklists, and by mistake>clicked on the fire extiguisher switch for engine #1. I then>set it back to normal position, and continued with the>checklists.>>When I went to start engine #1, it wouldn't kick over. It>just keep cycling over and over. I then realized what I had>done, and couldn't find a way to reset it without re-loading>the flight again.>>Is there a way to reset the fire system without having to>reload the flight?>>Thanks in advance,>>JohnWhat's happening is that triggering the fire extinguisher is cutting off the fuel flow to the engine, but not resetting the start lever.Try this:Activate the fire extinguisher and then put it back to the closed position.Cycle the start lever on the throttle pedestal a couple of times and leave it at CUTOFF.Engage the Start switch on the overhead panel, and then at the appropriate time, move the start lever on the throttle pedestal to idle. The engine should start normally.I've tried this twice now.

Thanks Timothy!- John