Hi all,Quick question I am using a T8 for various items with the PMDG737.I can make the starters move via goflight software on the overhead, however I have also programmed the fuel cut off and on levers via goflight software and they don't seem to be moving them at all in the sim?Progammed in goflight software as = Eng1_fuel_run_cutoff Eng2_fuel_run_cutoffDo I need to setup any keystrokes or anything?Has anyone got this working with a T8? Would be a real great thing to get working.I have seen a breif not that someone had got it working....Thanks in advance.Mark P

not sure if they can work through a keystroke, I think you need an axis.

Reading around I can see someone has got these two levers working individualy fine using goflight etc, there must be some way?!Thanks