Strange AI aircraft behavior

[Guest]

Hi, May I ask your help?Two strange behaviors with AI aircrat.1. AI aircraft stop on the runway after landing and never get out of runway for taxi. Seems this happens on any type of aircraft but A320 and MD80 are the most. I use Project AI aircraft. More strange is that same type of aircraft sometimes exit runway smoothly for taxi. Once an aircraft stuck on the runway, seems following traffic often end up with same result BUT sitll some are running as if there were no aircraft on the runway(just passing through stranded aircraft!) then move onto taxi to gate.2. Some aircraft make 180 dgree turns on the runway after landing and exit from a taxiway BEHIND! even though one more taxi way exist ahead of her.Suspect cause of this phenomenon as;- too much flights landing in certain time frame = too much flight plan?- something wrong with AI aircraft air file or cfg file?- Airport facility file glitch? This often happnes at a busy airport like KORD with add-on facility file installed.Appreciate any inputYuki

[Guest]

You Might want to check this Post out and reply also to your Problem. I believe it is a simular problem.http://www.projectai.com/Forums/topic.asp?...p,on,the,runwayMy Computer SpecsASUS P4 533 FSB2.4 GHZ Pentium41 GB Rambus RAME-VGA GForce4 TI4600 Video CardDigital Stereo 5.1 Surround Sound

[Guest JDH]

The taxiway issue will most likely be to do with the facilities data, i.e. the texture for a taxiway may exist but no track in the facilities file for that airport. Alternatively it may be something to do with how the aircraft selects which taxiway it will use, i.e. if it is a fraction nearer the taxiway behind it'll ignore the one ahead.

[Guest]

Oakridgecommunity, JDH, thank you for advise.I also assume that it is something to do with AFCAD facility file. So I have checked the install data with AFCAD. However, it appears that taxi-way and nodes are promptly connected with associated runway. That would be another evedence for the case aircrafts properly get out of runway. I try to search another clue for the issue.By the way, I am using AFCAD Ver 1.2. It seems the program does not support scroll up/down when the entire airport is not fit in the window. I need to reduce with - button but it becomes hard to see. How you guys get rid of it ??Regards,Yuki