Those of you that have PIC 767 with the CH Products USB Yoke and Pedals, what are the sensitivity settings (Ailerons, Elevator, Brakes, etc) do you have set in addition to any suggestions for programming the buttons for PIC? I have the Go Flight A/P Panel and Trim Gear Flaps modules. So I can take those features off the Yoke buttons.How do you have your Yoke and Pedals configured? So it reasonably resembles the actual control surfaces on the 767...Barry

I use the NON-USB version of the set you mention...I have Ailerons, Elevator's set to Nil "0" and the dead zones about 60% for both. I don't touch throttle settings.For rudders I visually calibrate them by repeatedly going in and out to see the rudder deflection until it matches the peddle movement, menaning full right peddle equals full right deflection on the rudder and no more or less, and so on... ;)I just downloaded the new ch drivers, installed them, haven't tried them yet but from what I've seen so far they look tight ! :)Hope this help's a bit.