How to manually tune NAV2/ADF?

[Guest]

How does one manually tune NAV2 and ADF in PIC and have them ident properly? I do not see the "usual" radio button shortcut anywhere on the panel,; neither can I use the FMC for the purpose.Thanks in advance.

[Guest]

The FMC NAV-RAD page will allow you to enter in either the identifier or the frequency for VOR2 which will then tune if in range. The ADF I am not sure about and I really can't remember a time I "had" to use the ADF, simply enter the ADF identifier into the Legs page if you need to fly around one. You can also use the pedestal manual controls to set VOR2 and ADF with the knob.This is also covered in the manual.Rob.

[Guest]

Thanks. Will try out today evening.