Hi all,I have read on a number of posts that a merge exists for the PIC767 panel and the IFDG 757 but, I have not seen a post detailing where I can find this merge. Does anyone know where I can get this merge?:-hmmm

Actually what it is, is a manual manipulition of the config file to have FS Systems tied to PIC logic. ---------------------------------------12849, "The Correct Way to Install PIC w/757"Wed Feb-12-03 12:31 AM For those of you that are not *sure* on how to do this correctly, here you go;1] Download your new IFDG 757v2 off Avsim's Library2] Open the 757 Panel folder, you will see the panel cfg, open it also and DELETE what's in there and place this;{FLTSIM}alias=767 PIC Wilco Publishingpanel3] Now do the same for the 757 sound folder's cfg file and place this;{FLTSIM}alias=767 PIC Wilco PublishingsoundMake sure to set the correct {brackets} around the words {FLTSIM} and {electrical} because I cannot post them here correctly, see attached jpeg pic! Last item to change is the 757 aircraft cfg file. Open it and scroll down till you see this; {electrical};BusType, MaxAmpLoad, MinVoltage BusTypes:0=MainBus,1=AvionicsBus,2=BatteryBus,3=HotBatteryBus,4-7=Generator/AlternatorBus(1-4)flap_motor = 0, 5 , 17.0gear_motor = 0, 5 , 17.0autopilot = 0, 5 , 17.0avionics_bus = 0, 10, 17.0avionics = 1, 5 , 17.0pitot_heat = 0, 2 , 17.0additional_system = 0, 20, 17.0marker_beacon = 1, 2 , 17.0gear_warning = 0, 2 , 17.0fuel_pump = 0, 5 , 17.0starter1 = 0, 20, 17.0light_nav = 0, 5 , 17.0light_beacon = 0, 5 , 17.0light_landing = 0, 5 , 17.0light_taxi = 0, 5 , 17.0light_strobe = 0, 5 , 17.0light_panel = 0, 5 , 17.0//0 Class <0=none,1=wheel, 2=scrape, 3=float>//1 Longitudinal Position (feet)//2 Lateral Position (feet)//3 Vertical Position (feet)//4 Impact Damage Threshold (Feet Per Minute)//5 Brake Map (0=None, 1=Left, 2=Right)//6 Wheel Radius (feet)//7 Steer Angle (degrees)//8 Static Compression (feet) (0 if rigid)//9 Max/Static Compression Ratio//10 Damping Ratio (0=Undamped, 1=Critically Damped)//11 Extension Time (seconds)//12 Retraction Time (seconds)//13 Sound Type//14 Airspeed limit for retraction (KIAS)//15 Airspeed that gear gets damage at (KIAS)You will replace that with this, copy it exactly!{electrical} ;BusType, MaxAmpLoad, MinVoltage BusTypes:0=MainBus,1=AvionicsBus,2=BatteryBus,3=HotBatteryBus,4-7=Generator/AlternatorBus(1-4)// FS Systems tied to PIC logic avionics_bus=0,0,1avionics=0,0,1flap_motor=1,0,1gear_motor=4,0,1starter1=0,0,1starter2=0,0,1light_nav=0,0,1light_beacon=0,0,1light_landing=0,0,1light_taxi=0,0,1light_strobe=0,0,1light_recognition=0,0,1light_wing=0,0,1light_logo=0,0,1marker_beacon=0,0,1standby_vacuum=0,0,1And happy flying !Best Wishes,Randy J. [email protected]" A little learning is a dangerous thing"AMD XP2100 |MUNCHKIN512 DDR RAM |ECSK7S5A MB |GF364 MEG |WIN XP PRO