HiDirk have now included the DME in the FSBUS.If you use the DME, you get the value for example 999 mil. by 99.9, but without the decimal period.I have solve that with the FSBUS DO, if the value is lower than 999 the decimal period in the display is going on, and higher its going off.A little hard to explain, but i hope your understand.RegardsFinnDenmark

Thanks for that Finn, Very clever!!I was just playing with the DME readout the other night & did not realise this problem existed....Well looks like I'm building a DO board now.Regards Glenn.

Come to think of it Finn, could you not use the LED board to drive the decimal point ?Have you already tried That?Glenn.

Hi GlennI do not have the LED board, byt i can not see any problem to use that instad, the +5 volt, is the same.RegardsFinn