Hi Everybody,I have some problems of Rudder trim,Aileron trim and IAS/MACH on FSBUS system ? 1.Is there any one who knows how Rudder Trim and Aileron Trims works on FSBUS? I've created a Display to observe the changes on RUDDER trim and Aileron Trim while I was trimming on FS. But I can't see any changes on this values. I used " FS.Standard.Aircraft Control.Rudder " as a destination of Rudder trim and " FS.Standard.Aircraft Control.Aileron " as a destination of Aileron Trim.So how can I control the Aileron and Rudder Trim ? Also Is it better to use knitter or pots for these controls ?Thanks for All

Opening my fsbus, by default i do no have Rudder Trim or Aileron Trim.I only have the value for the Rudder and Aileron themselves.The only trim i have is the Elevator Trim.If you used Rudder and Aileron, i think you used actual control axis position.So you can't see anything then 0 when trimming, because you're reading actual axis input (like joystick or keyboard input).

HelloYou can add aileron trim or rudder trimby creating your own variables in a "Myfsif.ini" fileThe offset are:Aileron Trim 2EB0 (Float64 DEC in radians)Rudder Trim2EC0 (Float64 DEC in radians)BOB

Hi Bob,Is it possible to show me a how can I add these variables ?

Yes I'll try to test it and then give you the linesNeed some time to do that.SoonBOB