I have programmed all the keystrokes for the PM CDU in to my FSBUS KEY board but when I run the CDU it does not see the keys.Once programed, should the FSKEY board transfer the keystroke associated with the key that was programmed - an "A"for instance? Should I be able to se these keys type in notepad when I press the key, like you would with a keyboard emulator?I have selected FS:PM.Keyboard Interfaces.CDU as the destination for the letter "A" as an experiment but it does not type in the CDU scratchpad.Any ideas about where I'm going wrong is appreiciated.

Did you take the ascii value for the letter "a"?take the fs source ---> keyboard interface---> cduI don't have problems with that.Jan.

No - I used the "K" codes - K+A;K-A", Etc. Is fsrouter supposed to be running when you kick off the CDU? What is the serial port driver that interrogates FSBUS?

Mitch,Fsbus should be up and running.After that follow the steps as I earlyer mentioned.Good luckJan.