Hi all,my project is progressing well.I am getting my panel laser cut and engraved, which looks really cool.I saqw on other sites, mentioning that using a white drawing ink in the engraving can make it stand out in 'normal' light.I have been looking for this drawingt ink, but cant seem to find it.Any suggestions on where I might ne able to find this (Not a specific shop, as I am currently in Singapore), and really what is it?I imagine its a really thin ink?What is the best method and tool to apply this to get the engraving looking good? I have played around a bit with paints, etc, but these tend to run out of the engraving and onto the paint.Thanks for any help.CheersChris G

HiI use Talens drawink ink (white) for that purpose. I do not know wheter it is available outside the netherlands.Talens is the manufacturer.regardsNorberthttp://home.wanadoo.nl/norbert.bosch

Thanks Norbert,by the way, how do you apply it to the engraved lines?I was thinking about using a pin/needle or something extremely fine?CheersChris

Thats is exactly how I do it Chris, Use the finest pin/needle you can get.Norbert