Hi.I have some issues whit FSbus io board,I

AFAIK, the fsuipc calibration is for "windows" joisticks.You only have tho connect the respective pot in fsbusrouter to you r destination, thats'all. No further adjustments in FSassignments or fsuipc is necessary.regardsnorberthttp://home.wanadoo.nl/norbert.bosch/

Thanks norbert for a very fast reply!i did that but in sim i turn pot it only gives vary small thrustonly 20% would be close. and turn it back to idle there comes reversesbut again only little power???Like pots would

Yes, you are right. These values come from the fsuipc sdk doc. In the fsif.ini is a mul/div setting. Then the sdk values are otherwise then the values you see in fsbussw.I know of problems with the pots in fsbus. Better not to use controls. Connect them to gameports (to usb convertors). It has to do with the speed of data transfer.I conencted my pots to fsadmin and I saw the full range off travel. Did not test them in the fsbusrouter till now. But if fsadmin is OK they should work. So keep trying and play with all the settings in the router sw.The value of the pots:, on page 10/30 IO doc the value of the pots is 10K.regardsNorbert

I had some very weird issues when I had previously assigned some axis to throttles, and they had some sensitivity settings in FS9 and also in FSUIPC calibrations for the axis - you could check your fs9 cfg whether it has some "phantom" axis calibrations still there even though you removed them from FS joysticks dialog.//T