Hello fellow rotor heads! I couldn't take it anymore and turned my old siatek joystick into a set of rudder pedals by locking the X and Y axis' and allowing the Z to rotate. I built pedals and supported it on a stand to allow for leverage from my size 11 1/2 feet. I had to reverse the Yaw setting assignments panel so the aircraft went the direction that it is supposed to go. Ok, here is the dillema I face now, when I use Anttis Dolphin (which by the way is all I use now) I have to have the letter "r" before the letter "Z" in the cfg file for the pedals to even work. If I remove the letter "r" the pedals won't work period. So what happens is when I give left pedal I go right and when I give right pedal I go left. And yes I disable my joysticks. I just want to figure out how to get the Dolphin to respond the same way the other aircraft respond which is the right way. Any Suggestions? Thanks in advance!

Hmmm... I don't think there is anything that you can change in the Dauphin.cfg to help you, your going to have to alter the pedals that you have created and physicaly change the way the Joystick/Pot rotates, e.g. you push left and the joystick rotates right (or viceaversa). When I made my pedals, I stripped the joystick right down, and took the Pot out and used that directly, when I encountered the same problem that you are faceing, I just turned the Pot upside down, and it worked! You could do something similar, or add some sort of gearing, or pulley that will reverse your input.Hope some of that waffle helps!Alun