Jump to content

Sign in to follow this  
Guest Tydafpk

Auto -Trim Failure

Recommended Posts

Guest Tydafpk

I installed my pss a340/330 on a brand new FS2004 and now the auto-trim will not work causing parts of the autopilot not to work and a constant backpressure on the control stick

Share this post


Link to post
Share on other sites
Guest vrandar

When is this happening? Do you need constant back pressure during normal cruise or just on the take-off roll. I suspect it might be the latter so make sure you enter pitch trim of -1.8. You adjust this by using the Home/End keys on your keyboard and watchinhg the figure on the F/CTRL page of the lower ECAM.One advantage of manually setting the pitch trim (which will then go to auto after takeoff) is that it makes it slightly easier for you to maintain V2+10 on climbout.Rob Elliott, EGPE InvernessPSS Airbus Support andAirbus Fleet Training Captain, British Airways Virtual airbus@speedbirdonline.co.ukhttp://www.speedbirdonline.co.uk/airbus.htmlhttp://www.bavirtual.co.uk

Share this post


Link to post
Share on other sites
Sign in to follow this  

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
  • Donation Goals

    AVSIM's 2020 Fundraising Goal

    Donate to our annual general fundraising goal. This donation keeps our doors open and providing you service 24 x 7 x 365. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. We reset this goal every new year for the following year's goal.


    10%
    $2,500.00 of $25,000.00 Donate Now
×
×
  • Create New...