I'm having problems with a merge that I did, I combined the SSW panel and AIR file to a HNAC A300B4-600. The panel works with the aircraft, BUT I switched the view to the outside of the aircraft while it was on the ground. The nose landing gear was off the ground maybe half a tire size and the main landing gear was in the ground up to the hubs or basically halfway up the tires. Something is wrong with the contact points I'm assuming, Any ideas to fix it or what I need to adjust in the config file?

I'm having problems with a merge that I did, I combined the SSW panel and AIR file to a HNAC A300B4-600. The panel works with the aircraft, BUT I switched the view to the outside of the aircraft while it was on the ground. The nose landing gear was off the ground maybe half a tire size and the main landing gear was in the ground up to the hubs or basically halfway up the tires. Something is wrong with the contact points I'm assuming, Any ideas to fix it or what I need to adjust in the config file?

Well, got some news, it didn't take me long, I figured the problem out. But I do have another question about it though. Does anybody have any cargo configuration for the SSW to replace the passenger station points in the config file. I'm leaving the originals alone in the SSW file, but I replaced the information in the HNAC config file to use the SSW panel. I'm just wanting the cargo load out for that one, to get the CoG right on the load out.

Just curious, what did you do if i may ask

Just curious, what did you do if i may ask

1. Backed up original aircraft config and AIR file from the HNAC model by putting .bak on the end of the files2. Made a copy of the SSW config and AIR file and put them in the HNAC folder3. Renamed the SSW AIR file to match the original HNAC air file name4. Opened the backed up HNAC config file to copy the [Fltsim.XX] info to transfer to the SSW aircraft config5. Scrolled down in the original HNAC aircraft config file to the [contact_points] section copied just that section and pasted over the SSW's [contact_points] section to fix the sinking landing gear problem and hovering nose gear6. Copied the Panel folder from the SSW to the HNACSo far so good its working without any problems. I'm just now wanting to redo the loadout stations to a cargo configuration but I'm trying to get some suggestions or some help to get it just about right so I can keep the CG correct