Jump to content

Archived

This topic is now archived and is closed to further replies.

Guest collotty

PDCS Problem with modes

Recommended Posts

Guest collotty

What am I missing? I have followed the procedure in the pdcs doc, and always the same result...doing the self test works, entering the temp works, i get the calculated epr for take off, once airborn i switch to climb mode.....and it stays in TO mode. in fact, it doesn't matter where i set the mode switch, it continues to show the full and reduced TO pages. any help or thoughts? i have registered version of fsuipc v3.75

Share this post


Link to post
Share on other sites
Guest collotty

never mind, problem solved, i uninstalled all panel files and reinstalled, works fine now, no clue what caused it. back to flying this awesome plane and panel! thx tinmouse II!

Share this post


Link to post
Share on other sites

×
×
  • Create New...