Sign in to follow this  
Guest metaleye

Altimeter

Recommended Posts

Hello to all;I have a question about the setting of the altimeter baro preasure. When I press the "B" to update the preasure in the altimetter over 10,000 to 29.92 it changes to 29.91. I'm using Go-Flight modules, the altimeter is supposed to change to 29.92 using this module. It works ok on some panels but on others it goes to 29.91. In what .cfg can I change some data for this to work ok.Thank you for your time.

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Helloooo!!!!I need some help here; pleeeeeaseThank you!

Share this post


Link to post
Share on other sites

You will find that some gauges show as 2991, you are doing nothing wrong. I have always found that while the pressure shown on the gauge is wrong the altitude is OK. Never have found out why but if you have two gauges on the same panel it is possible for one to say 2991 and the other 2992!Check your altitude by pressing SHIFT & Z after pressing B when the pressure is 2992 against the altidude shown on your altimeter to be sure. Wierd and very annoying isn't it!

Share this post


Link to post
Share on other sites

Gordius;Thank you for the time you used to reply to my question. Now I'm more relax about this situation. I was not sure if it was I or the panel's gauge the guilty one in here. I hope this will be fix in FS2004. Thank you.Miguel

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this