Jump to content

Archived

This topic is now archived and is closed to further replies.

gorlosky

Manifold Pressure - goes over design pressure ?

Recommended Posts

I have a question on the default Manifold_Pressure Gauge (used in the R22), which I borrowed for my craft.In the aircraft.cfg, for my craft, I have:[piston_engine]max_design_mp=25.000Why does the Manifold gauge needle go to 30 on full throttle ?

Share this post


Link to post
Share on other sites

Well the output of the MP gauge must have been associated with the RPM of the default R22, so I have 2 choices - tune the xml to the RPM of my engine or reduce my RPM and lower the gear ratio....decisions.... decisions... :(

Share this post


Link to post
Share on other sites

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
  • Donation Goals

    AVSIM's 2020 Fundraising Goal

    Donate to our annual general fundraising goal. This donation keeps our doors open and providing you service 24 x 7 x 365. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. We reset this goal every new year for the following year's goal.


    34%
    $8,560.00 of $25,000.00 Donate Now
×
×
  • Create New...