Ideas please - problems with MSFS2002 & DHC8-300 and CH Products Flight Sim Yoke LE

I am trying to use the CH 3-Axis 10-Button + POV USB Yoke with FS 2002 and the DHC8-300 add on. I have registed my copy of FSUIPC. However, I cannot get the yoke to work properly. Here are SOME of the problems that I am having:1. I am currently stuck with a cockpit view looking in the top right hand side of the cockpit - rather than at the main instrument panel. This is less than useful when trying to fly the plane! This problem has only appeared recently as I have been "fiddling" to try to overcome other problems that I have encountered when calibartaing the yoke.2. How do I change the assigments of the yoke buttons? I can get to the screen where the assignments are displayed - but cannot see how I change the yoke assignments.3. When I used to have the yoke working (of a fashion), the plane always veered left on the take off roll. Is this a fault - or realistically modelling the need for right rudder on the take off roll? If so, how do I input right rudder?I am confused about how to set up the Yoke - there seems to be something in the Settings / Calibrate Joystick as well as in the Modules / FSUIPC menus? How do these inter relate? I also have an ELITE item on my menu - as I originally intending using the Elite MEL throtle quadrant as part of my simulation (I had problems getting this to work reliably - so have put this idea on the back burner until I get the Yoke working properly)I would REALLY appreciate gettiing in touch with anyone who has been down similar paths in the past. Thanks in advance for any help that can be offered.Peter07801 735059 (I'll ring back if you want to discuss further on the phone):)