Hello!I have NGX since first released version, without ANY problem, NEVER ... Always runs fine in my system.Yesterday i installed SP1b, and today testing it, i see the following problem. Only this problem on ext view ...

Ticket sent

rerun your EZCA config.

rerun your EZCA config.

I'll test!Only happens with Ezca ext views!

FIXED!But another problem ...I have the AOA camera set installed for NGX. When i switch to a camera, for example, MCP, OVH, etc ... don't move!!! Only moves to selected camera if TrackIR isn't active ...I need to reinstall the camera set too?

I always knew that Boeing had a secret project in Area 51 !

hahahaha :)

FIXED!But another problem ...I have the AOA camera set installed for NGX. When i switch to a camera, for example, MCP, OVH, etc ... don't move!!! Only moves to selected camera if TrackIR isn't active ...I need to reinstall the camera set too?hahahaha :)

hmmm...not sure. Was not a problem for me but I guess you can backup and reinstall the camera set easily if you have 1.1.7

hmmm...not sure. Was not a problem for me but I guess you can backup and reinstall the camera set easily if you have 1.1.7

I'm not sure if is good explained ... Sorry but my english is no perfect. :)In this camera set, we have the pilot view, that i use with TrackIR, and the separate panel view, MCP, OVH, Thorttle, etc This view are good for setup systems, without movement of Tir ... But when i press the key assigned for example for MCP view in EZCA, don't go to MCP view, if Tir is active.

I'm not sure if is good explained ... Sorry but my english is no perfect. :)In this camera set, we have the pilot view, that i use with TrackIR, and the separate panel view, MCP, OVH, Thorttle, etc This view are good for setup systems, without movement of Tir ... But when i press the key assigned for example for MCP view in EZCA, don't go to MCP view, if Tir is active.

no i think i understood what you were saying. I also have TrackIR and what you're describing wasn't a problem for me. I'm just saying you could easily just reinstall the camera set just to see if it fixes it.

no i think i understood what you were saying. I also have TrackIR and what you're describing wasn't a problem for me. I'm just saying you could easily just reinstall the camera set just to see if it fixes it.

Ok ... I'll test it!Thanks for your help!

Ok ... I'll test it!Thanks for your help!

I assume you had this working before but you may want to double check your TrackIR settings within the EZCA application

I assume you had this working before but you may want to double check your TrackIR settings within the EZCA application

Yes working correct before ...Is fixed now! Only need to exit TrackIR application and reopen it!!! :) The PC misterys ....Thanks again for help me man ...