Hello!I've got a problem with Eric Marcianos A330 panel. I can not activate the managed alt mode in the FCU by pulling the switch. The selected mode can be activated normally, but when I right-click the switch I just get a deep beep sound and the alt mode of the FCU deactivates and the altitude I've set resets to 0. I have set the flightlevel in the FMC previously as described in the panel docu. I also fly Erics A320 panel where the managed alt mode works perfectly. I am using version 2.2 of the panel. Does anybody know a solution to this?thanks,Thorsten

I have this problem too has it been resolved ?

Ok i have sorted this, seems that it was not just me with the same problem.Pull up the INIT page in the MCDU then set the cruise altitude in the FCU. Once this is set push the button on the left of the Crz Fl label in the MCDU, this should now turn blue.Toggle to the second page of the PROG page and the Flight Plan and Crz Alt should read ok and the selected cruise altitude should be shown.When you now pull the altitude management button in flight it should work NP :D

Thanks a bundle for this hint - I really had this problem also and could not work it out.The manual is NOT very clear on this point - that you have to switch to page 2 of the PROG page to set it while the original is still blue is not stated.You have saved me hours of frustration. Thank you.