DCS: Electrical Systems

Yo-Yo a Russian forum since the new electrical system is currently working for DCS modules: W, at first we will see for the mustang, then be exported to modules and future. (Sorry for the translation)

http://forums.eagle....ead.php?t=98902

It so happened that electricians have got what they were expecting (well, discharged batteries, light bulbs go off, etc) was ready in time for the mustang Why so long for this?, Because it was not as simple as it seems .

 

A few details:

1 - Battery:

This needs to be charged and discharged, and this load capacity. Accordingly we give the download time and the power that can give us seguen such systems require battery. It is also affected by temperature. EMF and internal resistance depends on the degree of suction (more resistance and temperature. The more alkaline and acid is different radius will have a discharge.

 

2 - Lamps and Light:

The strength of the light depends on the current flow travez the filament, respectively - in the voltage passing through the lamp. The color tone also depends - Not done yet but will be seen later.

 

3 - Power Device:

It will be stable for most of the strain gauges in the circuit, readings depend on fluctuations of the supply voltage of the device.

 

4 - Electric motors and generators:

Also affects the starting circuit. Itself is the DC power circuit. Now the starter uses more electric power until the engine starts (points 2 and 3 must be connected). At the same time, once known the circuit travez current and resistance, their use may heat the ignition coil, reaching overheat if use is made excessive. To this we can extrapolate to a circuit that works with electric motors, which needs voltage regulators coming electric generator. The outlooks are bright for what is ahead.

 

6 - Consumption:

The use of electric current is a function of its resitencia, and depends on the supply voltage. But this simple resistance (taking into account a powerful nonlinear resistor filamenteo for not making the system too simple), heaters, etc. The current consumente complex machines more or less constant.

We have implemented the controller looks tensioón of K-14 (not outside its exact parameters), which significantly enhances its electromagnetism. The weapons are heated by heaters and when they fire, and subsequent cooling thanks to the surrounding air.

 

7 - fun part:

Group it all together. As a source, it may be something (imagine there sistemads, where two batteries connected in parallel, and also include individual interructores), and more - the batteries can function both as power supply and consumption, depending on the level of discharge and generator power. simple ohm's law is necessary. Several nodes, making it all the circuit theory. Now, you can start a battery in the other it is downloaded separately, for example, that the ammeter shows the generator has power, does not mean that the battery is charging. Both may work to deliver cargo either for these and for other consumer devices (not getting enough power to recharge the batteries).

 

Complicated? Normally. Thanks Olgerdý, integrating everything that exists in the electrical system.