August 29, 200421 yr Hello again FS pilots :)I've run into a small problem and I was hoping you panel-design gurus could please advice....The Boeing 777 panel in my FS2000 shows only 2 display screens: the PFD & a MFD (Multi Function Display - for the newbies :))As you all know there is a 3-mode display switch on the 2nd MFD to select:1. Navigation Display (ND)2. EICAS 1 (Primary Engine data)3. EICAS 2 (Secondary Engine & Fuel data)I wanted a third display on the 777 panel because I wanted to view the Nav Display *AND* the Engine Display at the same time. So using CfEdit I cloned the MFD. Now I have 3 pretty MFDs staring back at me from the panel - nice :)My idea is for the 3-MFD layout to be as follows:(PFD) (NAV DISPLAY) (EICAS)My problem is that when I turn the selector switch on the centre MFD the display on the new (cloned) MFD changes as well (and vice versa) :( I know this is going to involve opening the B777 panel.cfg file in notepad and adding some lines etc etc.And thats where you guys come in....could you *please* tell me what to add so that I can switch the displays on both MFD's **independently**Thanx much :)
Create an account or sign in to comment