October 1, 20205 yr I've been messing around with the settings for too many hours now, and can't seem to get any smoothness from my yoke controls in game. Works just fine in Xplane11. I've got a modified Saitek Yoke with a Leo Bodnar BU0836 board. FS2020 recognizes the board, and i've recalibrated the hardware controller in Windows 10 settings. I've gotten the roll and pitch axis configured in game to the board, and made sure the saitek config settings aren't also set to roll/pitch axis (I know that causes a ton of issues in Xplane11), and the sensitivity curves do make a difference, but the in game deadzone is basically 85% of the yoke physical movement, regardless of what DZ is set in game. Basically imagine turning yoke right to 75-80%, then at 90%, the in game yoke goes from neutral to full deflect right. I've searched all over, and either it's not discussed or I'm a terrible search person (probably the latter). Is there a way to configure where this setup is usable?
Archived
This topic is now archived and is closed to further replies.