January 18, 20224 yr Apologise if this has been covered else where. Whenever I connect my Logitech Pro Yoke to MSFS 2020 it’s not calibrated. When I try to look at the sensitivity settings there is a message saying No Calibration Data and the yoke axis is displayed hard to the one end of the display. If I try to move it from centre moving it only a few millimetres the reading jumps to the other end of the display. It’s working like a switch on or off. Left or right. It’s the same for the aleron axis. When I use joy.cpl it works fine and I can use FSX without a problem. I’ve used the calibration tool in FSX but that did not fix it. I’ve tried reinstalling MSFS 2020, uninstalling the drivers and using the Logitech calibration reset tool but with no joy. Any suggestions are very welcome. Thanks Telb60
Archived
This topic is now archived and is closed to further replies.