I had to reinstall W10 on my PC and then reinstall P3D V5.3 on another disk than the system disk. As it was before the reinstallation. My MCP II worked fine, including loe Yoke, Throttle Quadrant, Rudder Pedals, and Saitek's Swicth Panel.
I'm running with FSUIPC 6 and Linda 3.3.5.1364 in a "Modules" folder in P3D.
When I launch the simulator the LINDA program does not launch whereas it did before.
When I launch it manually I receive an error message which I attach below.
Thank you in advance for your help.
Jean-Luc - FCY-DML

This morning, on the advice of John Dowson, I reinstalled FSUIPC6 in an FSUIPC6 folder at the root of another disk than the system disk and I moved the elements of the LINDA 3.3.5 package there. no change regarding the automatic launch of the LINDA console.
So I run it manually and I get the following error message again.

So I run it manually and I get the following error message again.
Can you help me, I don't know what to do anymore because the MCP is detected, during the launch of P3D the lights of the MCP turn on and off. On the other hand, I tried in vain to find the MCP with VRiSim which nevertheless detects the Switch Panel

 

Sorry,
I had forgotten to have the devices recognized in the LINDA console at the Setup VRI Panels tab. Which is done now, but the LINDA console no longer appears in the W10 quick launch area and the switch panel is not launched. I'll try to fix it through the console.
I keep you informed.

That's what I thought, by manually launching LINDA I was able to activate the switch panel, I just hope I wouldn't have to do it every time I launched a flight with P3D...!

Best regards,

Jean-Luc FCY-DML