Hello all, 

I'm not sure if it's a user error or something else. When flight planning with Little Navmap all goes well until I try to program the flight plan into the aircraft, the departures, approaches, and arrivals do not match for the most part. I do have a subscription to the Navigraph and it's updated in Little Navmaps, I really would love to use  Little Navmap but at this point, it's unusable in my case that is. 

For Example: 

Flying from KTLH - KMCN the ILS approach on Little Navmaps is IJBEW and this approach does not exist when programming into MCDU or any flight computer, and I get different choices. 

 

 

If someone can chime in on this issue, perhaps I'm doing things wrong. 

 

 

2 hours ago, Velotrexx said:

Flying from KTLH - KMCN the ILS approach on Little Navmaps is IJBEW and this approach does not exist when programming into MCDU or any flight computer, and I get different choices. 

1st: you didn't write which simulator you use. There are some differences between sims so it's necessary exactly describe the problem.
For example, currently I'm flying under X-Plane 11 in Linux environment and I always write about this when I report problems.

2nd: in general you have to install the same Navigraph AIRAC version at LNM and simulator, then you have to load scenery library - <Menu>/Scenery Library/Load scenery library,
then validate by validate scenery library setttings (the same menu) and at the end the best switch to "Use Navigraph for navaids and procedures"

3rd: under my XP11 above procedure always work, and no problem with AIRAC

4th: probably you've got an old procedures loaded in LNM, for AIRAC2302 at KMCN my LNM shows procedures:
-ALLMN for ILS05, RNAV05
-CAYSE for RNAV14
-JOHGY for RNAV23
-EMBIJ for RNAV32
Which AIRAC do you have where is  IJBEW procedure?

Regards,
Piotr

Edited May 18, 20233 yr by ppgas