Archived

This topic is now archived and is closed to further replies.

Guest Nils79

'AFCAD' or TDB problem...

Recommended Posts

Hi,i hope this is the correct forum for my question - if not, sorry ;)My problem: i made a seaplane base and an 'AFCAD' file with ADE and it has besides the water runway also docks for parking.Now i try to make some ai-traffic and for that i used the TDB, but if i compile the file it says that there would be no parking places for my plane.Thats the airport data:YSRB,-33.868138902,151.262838095,0.0,G,0,1.00,Australia{ RUNWAY,3937,164,WATER PARKING,20.0,DOCK PARKING,20.0,DOCK PARKING,20.0,DOCK PARKING,20.0,DOCK PARKING,20.0,DOCK PARKING,20.0,DOCK PARKING,20.0,DOCK PARKING,36.6,DOCK PARKING,36.6,DOCK}My CustomAircraftSchedules.dat: DHC2-4,VH-AAM,10,TWO_HOURS,VFR{0010,YSRB,12,,00300100,YSRB,12,,0130}My CustomAircraftTypes.csv:DHC2-4,DeHavilland Beaver DHC2 VHAAM,124,30,70,50,1519,1500,WATER,8,DOCK,40,no,noThats the command i use: TrafficDatabaseBuilder /Airports=fs10.Airports.dat /AircraftTypes=CustomAircraftTypes.csv /Countries=countries_regions.csv /Schedules=CustomAircraftSchedules.dat /AutoSchedule=No /Output=traffic_YSRB.bglIt compiles the file but the ai wont show up in FSX.Any help would be highly appreciated! :)And i have to admit that i haven't understood all parameters in the 'fs10.Airports.dat'.It would be also very helpful, if somebody could explain them to me - i only know the position, country and traffic scalar.Thanks in advance!

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!