I added this to my Flyhawks.pnl file://////////////////////////////////////////////////// Any Gauge//////////////////////////////////////////////////[gage]anyl[bgno][unid]anyl92086300300[help]This is to help you see what you are doing[endo]but I get a message saying invalid gauge identifier. What does this mean? I think that the gauge is set up right, with that as the ID.Thanks alot

Hi (Fred?)Unless you've written a dll to run a custom gauge (of the type 'anyl') you'll get the invalid gauge message because Fly!II can't recognize the type of gauge when it reads the panel file. You must use one of the Fly!II gauge types.Hope this helps,Matthew.

Matthew --Yes, I wrote a custom gauge. I figured out the problem, I had told the guage a different identifier in the code than the one that I told fly. Once I got that fixed, then it was all down hill ;-)