Before starting the engines I would tell the FO start sequence two then one but when I command him to start the first engine after starting the second FS2CREW automatically goes to the FLAPS section without evening going through the after start flows. which leaves me to have to do it myself. This is something that recently started happening. I tried reinstalling FS2CREW and I even tried even uninstalled and then reinstalled the PMDG before reinstalling the FS2CREW but without any luck. My firewall was disabled and windows defender were disabled each time I reinstalled it. I'm out of ideas in trying to resolve this issue.
Also on a side note, the FO does not recognize my fuel levers in the cutoff position on my first flight so during the preflight checklist he responds "Are you sure?" to the fuel levers status.