I need to save my flight for example after takeoff check list but when i load this flight all the systems are in wrong position (anarchical) !!!! Can you help me ? thank'sPierre

Hi Pierre,Take a look at the Support section of www.precisionmanuals.com. There are some FAQs there that can help you out.From the web page:1) Saving and Resuming a flight en-route: Some of the design techniques we used in the development of the airplane cause problems when a user wishes to save a flight for resumption at a later time. We are in the process of changing some things internally and expect that in some future update we will have an airplane that can be "saved" and "resumed" without any hassles to you.... In the mean time, Anthony Merton, the FMC developer offered the following for those who wish to be able to save and resume a flight with the current version of the 737: Save a flight in flight.Restore the flight. After the situation is loaded, the aircraft will be stable with Autopilot in CMD mode. The pitch and roll modes will show ALT HOLD and HDG SEL and the autothrottle will be in SPD mode.At this point, clear the MASTER CAUTION (not necessary- but it's good practice!)Pause the simulator (not necessary but best!) Open the FMC on RTE pageSet your departure and arrivals (setting departure is not inhibited when in flight with blank FMC)Set a wpt in front of aircraft as activeComplete the route with wpts, stars, approaches and whateverActivate the routeGo to perf init and set the cruise alt at current alt, doing the same with MCP altComplete the perf page exec and there you are. The FMC will in this case go immediately in cruise phase and create a dummy TOC point at present aircraft position... Hit LNAV and VNAV and go go go!!!! Best,Vin ScimonePMDGwww.precisionmanuals.comhttp://www.precisionmanuals.com/images/forum/devteam.jpg