Jumping out of cockpit???

[Guest KoSmOs]

I have a very strange problem here with the 747. I tried making a flight from LIRF to EDDF. First waypoint would be BOL and the next IXUSI. When programming the FMC I can add "BOL", but the same moment I hit "I" (starting to type IXUSI) I end up outside the plane. I can see the cockpit, and the nose of my plane. Everything runs, but I can't change views at all. I used my keyboard to try this, and it happens again and again if I do this.My own little "solution" to the problem was to go to VITER and then DENAL instead of BOL and IXUSI and then continue on to the other waypoints.And just to make sure: I have a fully legal copy!!! This is NOT some "backup" that I found on the net... It is NOT craked in any ways, but the update is installed.Jakob

[Tabs 2,790]

Check your key assignments - perhaps the I key got assigned to some sort of spot or VC snap view?

[Guest KoSmOs]

Already looked into that one... It happens both when I use the FMC keyboard, and my own keyboard.