Hi Guys,Anyone have the Fuel selector(offset 0Af8) working in Fsbus.Im trying to get the selector to show None,Both ect.All it will do is jump between incorrectpositons.Dont know if its me or what.Look forward to any comments.ThanksLes

It ok now,just wasnt understanding something.Les

Hi LesI aam strugling with the same prob hereCould you post your lines for FSIF.ini regarding fuel selector ?Tnx in advance

>Hi Les>>I aam strugling with the same prob here>Could you post your lines for FSIF.ini regarding fuel selector>?You need to have "up" event only for the rotary switch - otherwise you get two events (old position going "OFF" and the new position going "ON" that mess things up. Depending on your particular physical switch these can happen either way around ("make before break" switch vs "break before make") - but just using the "up" event we can just ignore the "off" signal since we dont care about it.//Tuomas

Tnx for advice,dear Tuomas,i got your pointMy prob is in correct editing of FSIF file as i am not very familiar with the parameters of the offsets Actualy i was able to assighn fuel selector via joystic buttons but would prefer to do that via Fsbus as i am short with available free buttons

Hi Yoss,Here is the line i used2, "Fuelselect", 520, 0, 0x0af8, I16, 0,W,1,1,Then in FSbus assign Fuelselect to each selector position and make the up/down value in the router the same ie 0 for None,1 for All and 2 ect.Hope this helps.If you have any problems just ask.RgdsLes

GreatTnx a lot , Les