I bought the following items:AGT 737 MCPAGT 737 EFISAGT GEAR PANEL AND LEVEREPIC CARD USBdigital display controllerExpansion module3x ABA 64 ABA 64 Interface23 led displaysRotary module32 Point output module Alot of switches and lightsNow i have 0 knowledge of programming epic i am a advanced PC user but no programing.I have got 2 months to be exactly to get this runing i know it is short.I have read what i could but dont know where to start i don't even know whether i have connected everything right and i am to scared to connect any switches yet.Is there a way i can lit up all the LED displays?Please help me on this one. i only have 2 months and a lot of time.The epic card is installed on the system.Thank you in advance

You will need the 7-seg circuit card adapters. It will make your life SO much easier! $5 (US) for each card.. just be sure to buy the right one for your displays.Hopefully you have what's called 'Common Anode' 7-seg displays.If you only have 2 months (Sounds like a College project?) then y'all better start soldering! :-)http://www.em.ca/~cockpits/main.htm

I got 2 of them but do not fit on my A/PI have 23 leds which i am planing to solder on a board on each space on the A/P.I need a programmer i am willing to pay a few hounderd bucks for somebodey that programs me the EPICIt is not a school project i whish it was!:-)It is for this simulator in Spain:http://www.737pilot.net/prev2.jpghttp://www.fly737.com/sim1.jpgI wouyld like to have a scheme that tells me where i should connect each card too.Please help!Thank you

if you still need help go here.... http://www.epicmapper.com they can help you....Ron