Hey all.Thanks for the great site. Lots of great people and content here. :)I own a CH Products Flight Sim Yoke, Pedals, and Throttle Quadrant. I've been trying for hours now to get FSX to read the throttles properly so when they click into reverse mode, it will do so in FSX as well. Other than that, they all work fantastic!Does anyone have any previous experience on how to make this work? I've completed all of the calibration modules and set the null zones accoridngly (I think).. When I click it in, there's a no change - it just stays at minimum forward throttle.Any help would be greatly appreciated!Keep on flyin'!PJ

Hi PJ,Go to the CH website and download the CH control manager. This will allow for a button press when the throttles are full back. Then test ALL the buttons in CH manager to make sure you got it set up correctly.Then load FSX, go to controls, buttons (not axis's) assign F2 and repeat for the full reverse in the CH throttles. The bad news is I haven't been able to figure out how to reverse the right or left engine only with this method. Not sure why I would want to either. Good luckGary

>Hi PJ,>>Go to the CH website and download the CH control manager. This>will allow for a button press when the throttles are full>back. Then test ALL the buttons in CH manager to make sure you>got it set up correctly.>>Then load FSX, go to controls, buttons (not axis's) assign F2>and repeat for the full reverse in the CH throttles. The bad>news is I haven't been able to figure out how to reverse the>right or left engine only with this method. Not sure why I>would want to either. >>Good luck>Gary Thanks a lot Gary I got ot workingP.J.