Hello,First off great job on the 737, it looks great. Just one question...is there anyway to change the bottom beacon light from rotating to flashing? Thanks for your hard work!Zach

I too would like to know if it's possible to remove the reflection on the ground. I think it's a huge step in the right direction to have that reflection, but it would be nicer still if it flashed rather than rotated. :-)-TRhttp://www.itn.net/gif/itn/ua.gif[email protected]

There's no way of removing the rotating beacon or tagging it differently. It's coded into the model file. You can only add an fx beacon into the light section of your aircraft's config. So a STARTING POINT for your adding a light would be the following;light.XX= 1, 0.00, 0.00, -4.40, fx_beaconb ,Assign the next light number in line, so if the last entry was light.8, then this one would be light.9 and so on. first number sets it fore and aft, the second number sets it left and right (don't change that) and the last number sets it above and below the centerline reference. Adjust as needed till you get it in placed in the dome for the beacon thats there now.Each time you make adjustments, just click save on your config and reload the aircraft. You do not have to reload FS each time.Mike BaumannFlight FX Design GroupStewart Global Aircraft