Archived

This topic is now archived and is closed to further replies.

Rainbowtide

PMDG MD-11 issue with VATSIM

Recommended Posts

aloha allmy md-11 works perfectly well under all conditions, even so when flying muliplayer sessions.recently i discovered VATSIM and its community - it is great and realistic flying with ATC!in order to operate it now with FSX they recommend using FSInn/FSCopilot (newest releases).and this is where my issue starts:connected to vatsim with FSInn panel open, everything with the aircraft md-11 works well. until.... until i reach about FL240 or higher when my speed and climbrate drops. there is no flare in the fms (shows 3 dashed) but the higher i want to climb (e.g. FL320, etc). the ATS does not cope anymore. the altitude climb stops and so does the airspeed (for example rather than mach .81 it will stay at or around m .71 or less). when i manually override the prof to climb with a greater rate (say 1800 ft/min) the speed drops even lower.any suggestions or comment?note: any other aircraft in my current configuration and settings of FSX as well as FSInn will operate as they should.thanks for your imput and wishing you happy new year and as much happy landings :)marc

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

aloha allmy md-11 works perfectly well under all conditions, even so when flying muliplayer sessions.recently i discovered VATSIM and its community - it is great and realistic flying with ATC!in order to operate it now with FSX they recommend using FSInn/FSCopilot (newest releases).and this is where my issue starts:connected to vatsim with FSInn panel open, everything with the aircraft md-11 works well. until.... until i reach about FL240 or higher when my speed and climbrate drops. there is no flare in the fms (shows 3 dashed) but the higher i want to climb (e.g. FL320, etc). the ATS does not cope anymore. the altitude climb stops and so does the airspeed (for example rather than mach .81 it will stay at or around m .71 or less). when i manually override the prof to climb with a greater rate (say 1800 ft/min) the speed drops even lower.any suggestions or comment?note: any other aircraft in my current configuration and settings of FSX as well as FSInn will operate as they should.thanks for your imput and wishing you happy new year and as much happy landings :)marc
Are you using FSInn for wx or another add-on? Sounds like the TAT was way to high or the barometric pressure was off. If so you need to use FSUIPC wx smoothing for wind, temp and pressure.

Share this post


Link to post
Share on other sites