Go-Flight TQ6 Flap Offset Settings

I finally managed to set up my Go-Flight TQ6 Flap level for use with TM2. Below are the axis settings that need to go into the FSUIPC config file:[Axes.Boeing 737-200 Delta]0=0X,256,D,17,0,0,01=0X,DR,9830,16201,x01006D11,x012=0R,2563=0R,D,10240,13032,x01006D11,x03,x01006D11,x034=0R,D,3351,8378,x01006D11,x03,x01006D11,x035=0R,D,-2825,372,x01006D11,x03,x01006D11,x036=0R,D,-9416,-5649,x01006D11,x037=0R,D,-16384,-12052,x01006D11,x038=0R,U,-16384,-9792,x01006D11,x02,x01006D11,x029=0R,U,-7344,-2825,x01006D11,x02,x01006D11,x0210=0R,U,0,4096,x01006D11,x02,x01006D11,x0211=0R,U,7633,10612,x01006D11,x02,x01006D11,x0212=0R,U,13591,16383,x01006D11,x02Notes:1. Do not use the FSUIPC Joystick Calibration option to claibrate the Flap Level axis. Doing so will cause the flap axis to register values from 0-16xxx instead of 16xxx to -16xxx. For some reason, the Axis Assignment tab in FSUIPC does not read the calibrated axis values from 0 to 16xxx, but instead reads from 16xxx to -16xxx. So, don't calibrate your Flap Level Axis.2. These settings will provide detent settings for Flaps 1, Flaps 5, Flaps 15, Flaps 30, and Flaps 40 provided you install the Flap Detent plastic overlay that comes with the Go-Flight TQ6. Sorry, but there are not enough detents proide the other intermediate flap settings.3 Variances in joystick calibration and "noise" may require you to slightly re-adjust the values above. It's not hard to do, but here are some tips: a. Each "detent" setting begins outside of the detent, i.e. with flap level reseting against the little tab defining each detent. b. Each "detent" setting ends inside the detent and hard against the detent in the direction of movement, i.e. if flaps are moving down, hard against the down side of the detent. Doing so will ensure that joy stick noise doesn't cause uncommanded flap movement. c. Flap settings between full up and full down require you to set actions for both entry and exit of the axis range. Only except is for Flaps 30 going down and for flap 5 going up since there only setting beyond these flap settings (Flaps 40 going down and Flaps up going up).Any suggestions for improving these settings would be greatly appreciated.Hope this helps!Rich BollWichita, KS